Subcategories

  • No description available

    4 Topics
    17 Posts
    C
    Hello @lukec, I have sent you an e-mail with further questions.
  • No description available

    176 Topics
    734 Posts
    C
    Hello, if you wish to send us the unit for repair (if you suspect HW damage), you can read terms and fill out our form. Otherwise can you show me picture of the LEDs to see their exact state?
  • 111 Topics
    370 Posts
    G
    I have a rain sensor from VELUX VXPRVX00081. I would like to measure the voltage at the 220K resistor. I need the lowest current possible to avoid electrolysis on the sensor so I think I can't acheive the bottom diagram. With the top diagram, my multimeter read the correct value of the voltage. More water, more current, more voltage. But once plugged in the AIx the value return by the MCP3422 is always at maximum. I'm using an external 12V power supply because of the internal sensor heater. The grounds are not connected together. I'm reading the value from cpp program with WiringPi and mcp3422.h. The gain is b00, the sample_rate is b11 and LSB 15.625. I red The K factor from the EEPROM. Here the _read funtion: float Analog_Input::_read() { std::lock_guard<std::mutex> lock(*i2cMutex); float value; value = analogRead (MCP3422_PIN_BASE + this->getChannel()) - 16; //std::cout << std::to_string(value) << std::endl; value = value * this->lsb / 1000 * this->getK() / 1000; //std::cout << std::to_string(value) << std::endl; return value; } So why I can't read the value of the voltage on the resistor, how to do ? Thanks in advance. Giamba. [image: WhatsApp Image 2025-06-14 à 14.59.27_cbf19f60.jpg]
  • No description available

    21 Topics
    100 Posts
    G
    Škoda, protože věřím, že by stačilo udělat extension která by "jenom" používala jiné relé. Věřím, že bych nebyl jediný zákazník který by to využil. Ale i tak děkuji za odpověď.
  • No description available

    42 Topics
    138 Posts
    C
    Hello @Bart-Delaere, unfortunately there is no definitive answer. The 1-Wire bus is technically able to connect huge amount of devices, but reality depends on cable length, quality, noise from the environment etc, so this may be trial and error for users that do not install it daily. Unipi used to sell a hub/splitter, which we do not offer anymore. Sometimes, a surge can occur in the environment, which can take down the whole bus. Unipi units (except Unipi 1/Lite) have an option to restart the bus (the bus is not restarted during normal system reboot), you can look in the Modbus table of your unit if you wish to implement it.
  • No description available

    63 Topics
    238 Posts
    M
    Hi all, I would like to know, whether somebody try this issue. I have water meter with HriMei - this is measurement with output MBUS and pulses. My question is: what I need to display to values liter per second and numbers from counter cubic meters. The Weintek display has input RS485 or modbus I know, that I need some convertor from HriMei to Weintek Below I post some chart/scheme, but I don´t know if it right or not Please, send me some your view or solutions how could be work Thank you very much for any answer [image: 6df6cd29-7534-4e5e-8a53-60a7c1c27a41-image.png]