I've upload the configuration.
The Unipi is connected to wireless network but when i disconnect eth, i cannot access to the Unipi.

Latest posts made by MMCreativ
-
RE: Wifi connection
-
Wifi connection
Hello,
I have configured my unipi 1.1 in wifi on my AP but I cannot access it via mervis or on the web interface.
What did I miss in my configuration?
Cordially.
-
Count reboot
Hello,
I would like to know if there is a way with Mervis to count PLC reboots.
I’m in charge of a facility where there’s a lot of power outage and my client would like to check the reboot.
Thank you in advance. -
RE: Problem with Axon M205
I tried to reflash the installation but nothing happens. The LED of the nanopi remains fixed red.
Nothing is booting.
Is the card out? -
Problem with Axon M205
Good morning,
I’m encountering a problem with an Axon M205.
It does not start. When I power it up, I have no IP access and it is not detected by MERVIS IDE.
I tried to do a restoration with another M205 in my possession but I could not put the automaton in recovery mode.
What am I supposed to do?
Thank you in advance for your response. -
Recovery of a program
Hello,
I currently have several PLCs in use and I need to recover the program on device which I lost the source file.
They were programmed with Mervis.
Is it possible to retrieve via the interface fdb programs?
Thank you in advance. -
RE: Wifi communication between 2 unipi neuron
@tomas_hora Hello, I can set up a wifi network with a router and a bridge this is not a problem.I use Mervis.
Thank you.
-
Wifi communication between 2 unipi neuron
Hello,
I would like to communicate with each other 2 unipi neuron wifi because I do not have the opportunity to pull a connecting cable between my two boxes. Is it possible to perform this communication so that my first unipi sends a command order to the second?
Thank you in advance. -
RE: Mervis DB
Ok, that does not suit me at all, I need to collect a lot of data and go through a cloud does not interest me. I do not know if this has already been done but we display the data via the HMI on a web page, is it possible to add in the pages a script in js complement that would allow to send the data in a DB?