• Categories
    • Recent
    • Tags
    • Popular
    • Users
    • Groups
    • Search
    • Register
    • Login

    xG1W-2 1 Wire Gateway reset on power cut

    Scheduled Pinned Locked Moved Other Peripherals
    1-wirexg1w-2
    3 Posts 2 Posters 1.6k Views 1 Watching
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • K
      kalophain
      last edited by

      Hi,
      I have the xG1W-2 One Wire gateway very successful in use. The configuration with the Software via USB connection is quite easy and works.
      The problem is that the gateway seems not to read the values from connected sensors after a power cut. It could be that the gateway has lost its configuration. Currently it returns only -280 values to the Neuron.
      This behaviour is not very usefull for remote installation without direct access.
      How can I configure the gateway to store its configuration permanently?

      Regards
      Maayen

      K 1 Reply Last reply
      Reply Quote 0
      • K
        kalophain @kalophain
        last edited by

        To continue this.
        I had the possibility to load the configuration again on the gateway and I also switched the programming DIP switch. Next problem is that the Neuron does not receive any data at all.

        How should I configure the gateway? Any possbility to fix that without physical access?

        @Martin-Kudláček @tomas_hora any suggestions

        1 Reply Last reply
        Reply Quote 0
        • T
          tomas_hora administrators
          last edited by

          @kalophain if 1wire sensor is loaded to the channel, it's ID is stored in the non-volatile memory and so it should be restored upon boot of the gateway. Since the memory is tested on every piece, the probability that it no ok is really low.

          The DIP switch is used for firmware change and has no affect to the store/load of the sensors.

          Please make sure that:

          • the baudreate in Neuron and GW is the same 0_1569339863243_GW_pic2.png

          • check that the addresses stored in the GW and loaded from the neuron are the same 0_1569339910879_GW_pic.png

          • upload the latest FW 1.24 to the GW

          • loadand save the sensor to the channel multiple times

          1 Reply Last reply
          Reply Quote 0

          Hello! It looks like you're interested in this conversation, but you don't have an account yet.

          Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.

          With your input, this post could be even better 💗

          Register Login
          • First post
            Last post