Modbus RTU slave device not communicating
-
Hi,
I am having trouble getting a modbus slave to communicate with a Unipi Neuron.
The slave unit is a Parker inverter drive.
I have been trying to read a single holding register:
slave address 01
function code 03
read offset 1004I can read the register fine using a different device (programmed via codesys) but the unipi does not seem to be getting a response.
I am writing '13' to 'Neuron S10x_UART_config_1.01' to set baud at 9600
Watching the port monitor shows the sent message looks correct but it times out with no response. the timeout is set to 1000ms.Any ideas?
-
-
-
@tomas_hora where can i find this manual?
Parity is set correct. -
@pascal http://downloads.unipi.technology SW-Mervis
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login