@raubucs Can you share the whole project? Have you tried all of the RS485 lines?
RE: Cannot setup wifi connection Axon S105
@heikkim Hello, to enable wifi you should enable the interface in /boot/boot.cmd by commenting the followin lines (add a # at the beginning)
fdt set /soc/mmc@01c10000/bcrmf@1 status "disabled"
fdt set /soc/mmc@01c10000 status "disabled"
Then run mkimage -C none -A arm -T script -d /boot/boot.cmd /boot/boot.scr and reboot.
Does it work?
RE: Ethernet bridge
@leif-edh That is doable but you would need to setup WiFi access point on one of those M205 (find a tutorial for hostapd), and enable bridging (available in bridge-utils package).
If you won't use static IP addresses, you would have to also setup a DHCP server on the WLAN and eth, br interfaces.
This tutorial might help you a bit: https://www.cyberciti.biz/faq/debian-ubuntu-linux-setting-wireless-access-point/
Another option is to put a router AP in the middle of it all.
Also, note that the internal wifi antenna does not have much gain and is inside an aluminum box so the range is limited...
RE: Are standard library delayed switches (Ton, Toff, Tonoff) non-blocking? 1wire reliability
Hello @clueless ,
yes the delay switches are non-blocking for the rest of your program.
If you have Neuron or Axon that is already prepared in the HW and available in Mervis as a OW_off variable. If you set it to true, the whole bus is shut down.
If you have UniPi 1 then this is a good start but note that 1wire devices are powered by the data so this reset must not be enough.
RE: Opakovaná časová akce
Dobrý den, @safranekj,
pokud opravdu nechcete aby se funkce LT vykonavala pri kazdem cyklu, doporucuji opravdu pouzit na vstup en funkce LT vystup z PulseGenerator. Jen pozor na to, ze ikdzy funkce LT bude mit en na False, stale bude mit na vystupu defaultni hodnotu.
RE: Error in the description: Node-RED on UniPi Neuron PDF guide (EN)
@stonefieldlab Thanks! Will fix that :)