Ok thanks for the answer.
How many sensors can a Unipi light handle.
I have connected 15 sensors now and the 1-wire bus stops after about 5 hours and requires a reset to work again.
Posts made by zorro_66
-
RE: Automatic restart of the 1-Wire bus
-
Automatic restart of the 1-Wire bus
I use a Unipi light and would like to use the function automatic reset 1-wire bus where do I find the variable OW_off_1.
The manual for this function is very poor -
RE: Mail on Unipi Light
ok they're just as good then I'll get further troubleshooting
no i know ssl is not working that's why i have a separate relay server -
Mail on Unipi Light
I have set up my own smtp server for alarm handling by mail
It works perfectly with my Unipi but I it´s not working with my Unipi light, it's not possible to send mail with a light ver.
It does not seem to be in touch with the smtp server.
I'm using Mervis. -
Send mail
How should I do to send mail from Unipi 1.1
There is no way to enter Authentication TLS
all mail systems require it.
Or have I missed something
-
Error setting time in plc
I can not change the time, I receive the following error message
Unipi light with latest Mervis
Error PLC 0 1 Failed to set controller time(WriteFailed). -
RE: No Value
Yes embarrassing.
Now it has happened to me too
thanks for the help
now it works -
No Value
I am using latest Mervis and a Unipi Light with the latest firmware
but get a problem see picture.
Anyone who has a solution
-
RE: Problem recognition 1w-Wire
Page 26 of the manual
Set the PLC to Commissioning mode –Right click on the PLC icon in Solution Explorer and choose PLC Operation→ Commissioning mode
-
RE: Alarm indicator disappears when active
I have the same problem and have not managed to solve it.
Here is the answer I received in a previous thread -
RE: HMI Problem
Thanks for the quick reply Tomas
Well, I know I had nothing connected to that block but did not think it was the fault.
Because it's on the position my time_Converter was supposed to enter.
Which two programs have I mapped that are not available -
RE: HMI Problem
Hello
Tomas, you've probably got a link to Dropbox and my project
Sorry it took some time to fix but i have been on vacation -
RE: HMI Problem
How can I send the project to you i tried to mail but it did not work.
I can not upload this one has no privileges so it's enough -
RE: HMI Problem
Indicates that it is wrong in any column
But the error changes depending on where I have the cursor standing
-
RE: HMI Problem
I have tried to do the function block
But i just get "build fail."
Do I have to write any more parameter in the block or matter it works directlyFUNCTION_BLOCK IntlToSec VAR_INPUT seconds_int: int; END_VAR VAR_OUTPUT out_time : TIME; END_VAR out_time := mul_time(time#1s, seconds_int); END_FUNCTION_BLOCK
-
HMI Problem
I want to control the time of my timer block with HMI
How do I want to use SET
If I enter the value 20 in the SET box, it will be 21 hours and 21 minutes.
I only want to use minutesThankful for help or a kick in the right direction