@Iogo
i bougt a unipi 1 with a rasp 3 from you
mervis coult noch attach plc properly

@Iogo

yes i know but upload failed
I think unipi board is dead raspberry is woring
is the there a chance to test it
http://192.168.0.98:8088/ the evok control bord shows no relays ?

@tomas_hora

if i coonect manualy i am ask for a divice identifer
is it important ?

@tomas_hora said in Could not find PLC via UDP:

yes i have done this
i can connect to unipi via ssh without a problem
but no chance to connect via plc attach mervis

Hi

when i attach the unipi 1.1 i bougt last week
it did noch found a plc via UDB Broadcast

i tried it manually , without a device identifer because i have no!=, but when i try do deploy a solution then it did not work

mervis result :is controler is only partly attached