Hello already for a long time we program the UNIPI via Mervis.. Now I would also start to use the Codesys.. I would like to know that image was preloaded on the Unipi... because in the Mervis there is an ISO image to be put on SD card.
TriathletC
@TriathletC
PLC programmer for thermoregulation and home automation
Latest posts made by TriathletC
-
INFO Codesys
-
Enocean
I'm sorry I need information. The neurons I read about have the possibility of Mervis reading Enocean sensors. Now I would like to know .. if I buy Enocean wireless sensors ... can I interface them directly with Neurons?
-
RE: Tool Tips in HMI pannel...
Unfortunately I'm not practical .. could you help me?
-
Tool Tips in HMI pannel...
Good morning I would like to know if in Mervis in the software to create HMI .. it is possible to set the Tool tips on variables to read and buttons .. I would create a HMI for blind people .. and I needed the tool tips function to associate it with the application of windows 10 that reads at the hover and translates into audio.
-
AO signal 0-10 V in parallel
Sorry guys you can drive two modulating valves 0-10v with a single AO signal of the neuron? Put the parallel signal from problems at the analog output? does it hold the load?
I need to know this because I definitely have to drive in parallel with a single 0-10v signal two fancoil with inverter ..
-
RE: barometric sensor on i2c
In theory and in practice you have to try to connect it and make attempts ... with the existing libraries.
-
barometric sensor on i2c
hello I would like to know if it was possible to acquire and install a barometric sensor on I2c bus.The following is used as an I2c library.
-
RE: M-Bus in Neuron (for heat meters)
I apologize, I wrote the domnda badly before.
I ask if I had to interface with the type of probes that communicate in Modbus rtu a ... is it possible to connect them directly without any converter or gateway to the NeoRon Rs485? -
RE: M-Bus in Neuron (for heat meters)
Forum use a modbus rtu accessories, you do not need any right gateways? just connect the two wires to the rs485 neurinoma port right?