Re: Cannot see 1wire sensor in EVOK
Hello everybody,
I started from scratch and configured everything that should be configured, but I still don't see the 1wire sensor under /sys/bus/w1/devices.
I suspect that my RJ-45 connector is incorrectly connected. My sensor is a DS18B20 with 3 cables (red, black, yellow).
How do these cables have to be connected in the RJ-45?
Many thanks in advance
-Luk
I'm pretty new to this topic, so do not be angry if I did something wrong or forgot.
I connected my UniPi with my Raspberry Pi, installed Raspbian, EVOK and Pimatic.
I can see all the values in EVOK and can also control my relays via Pimatic.
However, if I connect a 1-wire sensor, it will not be detected by EVOK.
Do any other configurations need to be made here?
Thanks in advance.
Best regards,
bibabutzemann