loosing 1-wire DS18B20 sensors during opreation in node-red
-
I'm having trouble with EVOK, when I read 1-wire (DS18D20) sensors in node-red flow, after some time sensors are lost (if I look at uni.pi.ip/rest/all, for sensor ID I get "lost": true). If I restart EVOK service, no 1-wire sensors are shown.
Is there any known solution for this?
BR Luka
PS. I am running Rasbian on RPI3.
-
Update: as mentioned only software reboot is not enough, I have to unplug and plug UNI.pi board to electricity to have 1-wire sensors reading again.
Could it be, that this is hardware problem (for connection I use standard UTP patch cable)?
-
@lukec Read through the: https://www.unipi.technology/hardware_documentation/1-wire-network-46
-
tnx for quick reply - will try to ground FTP cables and will report back.
-
I did as sugested I grounded cables for 1wire network connection. But it doesnt solve the issue.
I guess it has to be power issue - I have 1x Unipi, 1x Rasperry Pi 3 and 1x EMO-8R module in addition 14x 1wire DS1820 temperature sensors.
I am trying to figure out maximal power needed and so far I come with:
1.5mA/1wire DS18b20
1.5A/Unipi+RPi - 2.5A - RPi 3 model B (but only 1.1A is provided through Uni.pi) in opreational mode 250-500mA, that leaves around 1A for UniPi board and another 750mA for EMO-R8.Bottom line 2.4A should be enough for uni.pi main board, but not necesaray for extension module - could this cause 1wire lost problems?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login