Attach PLC over VPN failed



  • Hi all,
    i installed AXON in exchange station and now i need change PLC program. But i cannot connect PLC and when i start deploy solution, it write that PLC is only partially connected.

    How can connect the PLC without going to external place?


  • administrators

    Hi @derinex,
    to attach to the PLC via IP and port is a bit confusing.

    First, attach manually by filling the IP, port and the model of the PLC
    Then proceed with attaching via "Use deploy parameters"

    After that, you should have the PLC fully attached.

    Best regards,
    Martin



  • Thanks Tomas,
    its slightly confusing, but it works. In Deploy i must switch to Range instead of broadcast.

    Petr