Digital output problem
-
Hi,
I am using neuron S with raspberry pi 4. I noticed that I was unable to control DO2 and DO3 whereas DO1 and DO4 works correctly.
I checked resistance of each digital output. Resistances between DO GND <> DO2 and DO GND <>DO3 are very low (~ 50 ohm) whereas DO GND <>DO1 and DO GND <>DO4 are high.Did I break hardware ? If yes, can I send it to repair or can I fix it ?
-
Hi Tad,
When making a complaint or repair, follow the complaint procedure: https://www.unipi.technology/return
In this case, however, it may not be a faulty HW, but only an inappropriate output setting:
- The digital outputs on the Unipi units also enable the so-called PWM mode, where the output is controlled in a different way than during normal on / off switching.
- Another function that could affect the outputs in this way is the so-called DirectSwitch function.
If you work in Mervis SW, you can upload the default configuration simply by creating a new project in the Mervis IDE, assigning a PLC and uploading the Unipi module configuration.
For other SW solutions, I recommend checking the values in the Modbus registers.
- To check that PWM is off, check registers 16 to 19, all of which should contain a value of 0.
- To check that the DirectSwitch function is turned off, check register 1014, it should also contain the value 0.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login