Mervis & Stepper motor
-
Is it possible to control from Mervis a Stepper motor, and if yes whats the recommended way of doing it, Modbus, I²C?
I want to control 4 small stepper motors.
-
How do you physically want to drive them?
-
@tomas_hora
Sorry, I did not see your reply, so I was thinking it could not be done.Here is what I wane do:
I wane use the UniPi also as a feeding computer, that can control the amount plant nutrients, in our greenhouse.
I wane control 5 peristaltic pumps with 12v Steppermotors, 1 big peristaltic pump, that pumps 5 ~ 900 ml/min water, and 4 small peristaltic pumps 0 ~ 25 ml/min, that add the nutrients to the water (I need to ad 0.25 to 3ml/L of different type of nutrients), where they get mixed and then distributed by hoses and controlled solenoid valves to the plants.
Peristaltic pump:

I would like use this board to drive the stepper motors, as it is a very affordable solution.
And it comes whit this software to control the stepper controller, but it I think that software is not easily gone work whit UniPi.With most other solution is also using a Windows driver, so I am up for any other controller solution, if you have any affordable recommendations, I only need to control the rpm's, the 4 small pumps uses 0.75A and the big one 1.8A with both in a 12 or 24V current version.
Is there a way to this with MERVIS, or one with one of the other software solutions supported by UniPi?
For information, here is what I also wane do with the UniPi for determining the best software solution:
I also wane measure the soil moister content whit this sensor, to adjust the amount of watering.
(there is also a RS485 version for if I wane use L503 Neuron, and the maker is also thinking/developing a 1wire version)Next, to that, I wane control some relays, led drivers and a fan, both with 0~10V, and 1wire U1WTVS and a temp sensor for the water temperature.
I also wane make a weekly feeding schedule, where the amount and/or type of nutrients gets auto adjusted as the vegetables grow.
-
Hello @Havor,
you cannot implement such boards in Mervis. I suggest using Modbus (RS485 or TCP) devices because implementation in Mervis is really easy.
A weekly schedule is also a function block of Mervis.
I cannot tell much about the other SW solutions as we do not have much experience with them....
-
@tomas_hora
Hi TomasWhat type of controller works best with Mervis? 1 on 1 direct steering, semi-direct or pre-programmed?
Would something like this Mitsubishi PLC work in slave mode, and would it be more or less plug and play in Mervis, or would I need a other solution?
I think that I would have no real problems whit Mervis itself, but if setting up requires a high-level knowledge of protocols it will get hard for me.
-
Hi @tomas_hora
Any answers/suggestions on what type of controller I should use?
-
@Havor I do not have any experience with Stepper motors connected via Modbus so I cannot tell... But implementing any TCP or RS485 Modbus device is pretty straight forward in Mervis. You just need to map the registers you wish to read from/write to the Modbus device...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login