I'm pretty new to the Unipi / Unica and the 1Wire bus.
I've got the Unica U1WTVS sensor, the Unipi rev 1.1 board and of course a Raspberry Pi 3, running with raspbian Jessie.
I read the Documentation and made an RJ45 cable like shown in the unipi manual. I connected the Pins to the UNICA Sensor. When I open the unipi control panel, no 1Wire devices are shown.
So my question is, if there's a tutorial or explanation how to connect the unica sensor and get it's data on the control panel. Do I have to make some preperations in the evok api?
edit: When I start the /opt/evok/evok.py i get the following message:
Listening on port: 1025
Entering measure loop
Entering 1wire loop
Unsupported 1wire device DS2438 (2675FA0C02000054) detected
I'm grateful for any help!