Changing Sensor Interval with Mervis

[csacher]

Hi all,
is there a way to change the sensor reading interval of a DS18B20 with Mervis ?
Changing a config file on the PLC is also fine but without using evok.

I have a problem with 8 x DS18B20 connected to my Axon L205. I only get new values approx. every 15 secs and this is unfortunately not sufficient for my purpose.

Thanks, greetings

[Martin Kudláček]

Hello @csacher,
this interval is not changable and it is based on the way the Mervis polls the data from sensors. It doesn't use the broadcast reading, but instead it reads each sensor separately. This way of reading is more resistant to errors.

Best regards,
Martin