Hi Thomas,
Thanks for the reply. I already tried this in all ways thinkable.These would be the connections I already done:
p6+p7 on 1-W
p4+p5 on 5V
p3 + p8 on GND
I also tried with 1 cable each.
After a successful connection, I could plug it in in the 1-Wire extender an after entering in the console owdir, I should see a new sensor, or not?
At the moment I got the following:
root@unipi:~# owdir
/28.101160070000
/28.F3CF5F070000
/28.B7605F070000
/28.7F025F070000
/bus.0
/uncached
/settings
/system
/statistics
/structure
/simultaneous
/alarm
I already have connected 4 temperature sensors, is this an issue? And how can I verify if the connection the the UNICA sensore is fine or at least if the sensor is broken?
Thank you and best regards
Fabian