One wire how to connect
-
Hello,
If i read the documentation well, the one wire thermometer is connected via an one-wire IC.
This IC is connected to the I2C-bus.When i configure the I2C-bus, i can't chose the one-wire thermometer.
Does anyone know how to connect te one-wire thermometer and how to configure it in mervis?
Kind regards,
Frans Sleddens
-
Hello,
If i read the documentation well, the one wire thermometer is connected via an one-wire IC.
This IC is connected to the I2C-bus.When i configure the I2C-bus, i can't chose the one-wire thermometer.
Does anyone know how to connect te one-wire thermometer and how to configure it in mervis?
Kind regards,
Frans Sleddens
-
You need to create a channel for each bus, you cannot add 1Wire device to different bus. So add a new channel - PlaformIO - 1Wire and than add 1Wire device as you like.
You only need to add the 8channel 1Wire expander to the I2C bus but not the ONBOARD IC - that runs by default.
-
Hello Thomas,
thanks for the quick answer.
Il try it this week.Kind regards,
Frans Sleddens