Is there a manual in all functions of Mervis HMI.
Can someone explain how the alarm function works
Best posts made by zorro_66
-
Mervis HMI
-
RE: 1 wire net dies "Problem solved"
Problem solved, I finally found a bad solder
at the VCC pin caused power loss in my 1-wire network
Latest posts made by zorro_66
-
RE: Automatic restart of the 1-Wire bus
Ok thanks for the answer.
How many sensors can a Unipi light handle.
I have connected 15 sensors now and the 1-wire bus stops after about 5 hours and requires a reset to work again. -
Automatic restart of the 1-Wire bus
I use a Unipi light and would like to use the function automatic reset 1-wire bus where do I find the variable OW_off_1.
The manual for this function is very poor -
RE: Mail on Unipi Light
ok they're just as good then I'll get further troubleshooting
no i know ssl is not working that's why i have a separate relay server -
Mail on Unipi Light
I have set up my own smtp server for alarm handling by mail
It works perfectly with my Unipi but I it´s not working with my Unipi light, it's not possible to send mail with a light ver.
It does not seem to be in touch with the smtp server.
I'm using Mervis. -
Send mail
How should I do to send mail from Unipi 1.1
There is no way to enter Authentication TLS
all mail systems require it.
Or have I missed something
-
Error setting time in plc
I can not change the time, I receive the following error message
Unipi light with latest Mervis
Error PLC 0 1 Failed to set controller time(WriteFailed). -
RE: No Value
Yes embarrassing.
Now it has happened to me too
thanks for the help
now it works