Thank you,
And I can do this how?
best regards.
Hello,
I have a situation:
This simple example set input directy to output, so I have two problems:
1º If this input active then output is ON, and if I reboot the RPI, the output stay on, there is any away
that if reboot the output turn off?
2º if I turn on the input during boot, even when the boot is finished the output is not on, the input has to be turned off and on again for the output is on, there is any away to chek this?
thanks
@martin-kudláček said in Unipi Control Panel password:
control panel
Thank you,
Where I disable control panel?
Hello,
Any way to set a password to "Unipi control panel" ??
I new on node red.
I trying map a simple input to a relay bu Node red unsing Unipi, ai use this example:
https://flows.nodered.org/node/@unipitechnology/node-red-contrib-unipi-evok
The "Unipi Control Panel" tell me that the comunication is working, the WS ip is set and is connected, but for some
reason the output is not working.
the debug is tell me the same:
There is there any other detail you should configure?