Could not find PLC via UDP
when i attach the unipi 1.1 i bougt last week
it did noch found a plc via UDB Broadcast
i tried it manually , without a device identifer because i have no!=, but when i try do deploy a solution then it did not work
mervis result :is controler is only partly attached
did you insert the microSD card in RPi with the Mervis image according to the step by step guide? Do the LEDs on the LAN connector blink when you have the cable connected to UniPi and to your router?
if i coonect manualy i am ask for a divice identifer
is it important ?
At first it needs to be connected to dhcp. Then UDP works. After you have first made successful contact you can update the ip-address and disable dhcp.
You need to update the controller via: PLC -> PLC operation -> PLC setup -> Upload Configuration
Correct me if I am wrong :)
I was in the assumption that the unipi = raspberry with extra modules.
i bougt a unipi 1 with a rasp 3 from you
mervis coult noch attach plc properly
@ufa If you can ssh to the RPi with Mervis IMG on it, issue 'systemctl status mervisrt' and you will see if it runs OK.