Analog Output operation
I have Unipi 1.1 connected to Raspberry Pi. I want to use the Analog Output voltage which is coming out from the device. The details in the documentation are a little confusing. What does AOV mean (It is mentioned for external 12V) and to get the output voltage (0-10VDC), should I connect across AO and GND? (I will be using internal 12V from the Unipi itself)
Martin Kudláček last edited by
as the technical documentation says "External voltage must be connected to the AOV connector with maximum voltage of 35V DC.".
If you want to have analog output between 0-10V, you need to apply >= 10V between AOV and AOG. Then set the AO to 100% via software and lower the value to match the 10V via blue on-board trimmer.
@martin-kudláček Thanks for the response. Will try that out.