Raspberry connector cable pinout



  • Hello, I have an old RaspBerry that I'd like to my UniPI board (rev 1.1).
    The provided cable doesn't fit, as it's a 40 pin cable and my board is a Model B Revision 2.0.
    The provided leaflet doesn' t explain a lot, and the manual I've downloaded from http://unipi.technology/wp-content/uplo ... ual_en.pdf is not so clear to me.

    Can someone point me to a pinout design or description like: UniPI pin 1 -> rasPI pin 1, etc... ?
    Thanks



  • Hello, I have an old RaspBerry that I'd like to my UniPI board (rev 1.1).
    The provided cable doesn't fit, as it's a 40 pin cable and my board is a Model B Revision 2.0.
    The provided leaflet doesn' t explain a lot, and the manual I've downloaded from http://unipi.technology/wp-content/uplo ... ual_en.pdf is not so clear to me.

    Can someone point me to a pinout design or description like: UniPI pin 1 -> rasPI pin 1, etc... ?
    Thanks



  • Hello,

    as stated in the product description the cable we ship is for the RPi B+/2 versions. However we still have some cables for the old RPIs on stock. If you buy anything (where shipping fee is included) we will also put a the old cable in the package for free - please make sure to write a note to your order to put the RPI model 1 cable.

    This is also a good point for everyone, if you have an older RPi please write it in the order note while completing order.



  • Thanks for your reply, is it possible to have the pinout for the cable or am I forced to buy something?
    Come on! I thought this was an open source project!
    Thank you



  • Of course you can make one… It is 1:1 cable, no pins are mixed. There is a description of what pin goes to which device, just check the documentation