@Eanna
You can use e.g the rc.local file, as with standard Linux. Another option would be systemctl, which is what we use ourselves, but it is more complex.

See: https://www.raspberrypi.org/documentation/linux/usage/rc-local.md

This question isn't really related to EVOK though, so I've moved this to the UniPi 1.1 section.

You'll have to use your own ip address of course, hence the e.g.

@TriathletC That is not possible. The UART port is a TTL level serial port, not an RS485. Since UniPi 1 does not have an RS4885, you can use a USB-RS485 converter.

@TriathletC The IP changes because the ADSL router is a DHCP server that assigns the IP addresses randomly after each reboot to each DHCP client (eg. your PC and of course UniPi).

If you do not want this, configure UniPi with a static IP address in PLC parameters within the range of your network.

Ok tanks

Vytvořil jsem novou globální proměnnou "Local Time" a v režimu ladění už mi správný čas ukazuje. Díky.

Ještě mne prosím zkuste nasměřovat, aby se jsem tu novou lokální proměnnou dostat do HMI, popřípadě kde ji mám v dostupných promměnch hledat

0_1511470123921_Promenne.png

@Nick-Cullen You can try to stop the timesync daemon (systemctl stop timesyncd) and issue the command again

I don't want to give up the classical switches, which operates on 220V.
In this way the each light will be almost independent on UniPi, which could be installed in house later.
(Only each relay of UniPi will be replaced by hard-connected cables to simulate 3-way switch)

Why do you thing my design is not possible?

@c.man I have not seen one but basically, you need a 5V USB battery which will be able to charge and be charged at the same time

@sabrus No future versions for RPi are planner right now. Only the UniPi 1 , UniPi 1 Lite and UniPi Neuron.

@tomas_hora
Fixed Thomsas .. I connected UNIPi to the network and I redesign the detect .. once found through the Mervis I have downloaded the settings .. it works ..

@tomas_knot thank you.

@devien Have you tried to implement debouncing of the DI?

:smiley:

@DABIN Make sure that the SPI communication is disabled.

I have changed Cable now and this should clear all disturbances
and then I have grounded shield in the control cabinet
alt text
alt text