Dear All Users,
Do you have any experience to bring signal comming about lower electricity rate (in czech republic HDO) into Neuron ? I want to bring information into Mervis program, when it can activate heaters in low rates.
Thank you.
Dear All Users,
Do you have any experience to bring signal comming about lower electricity rate (in czech republic HDO) into Neuron ? I want to bring information into Mervis program, when it can activate heaters in low rates.
Thank you.
Dear All,
Has anybody experience with installing Node red into Neuron ? Is possible use DI and 1Wire sensors as input into Node red and DO, RO etc. as output in it ?
I want to catch MQTT messages (from different devices) and use it as input for Neuron action (simple - Nanopi will get signal on DI, generate MQTT message, send it via network to Neuron and Neuron switch on relay).
For any experience I will be happy. I will try to do it by myself and if I will have any succes, I will give information there.
Thank you
Hello,
I am trying to configure 1wire temp sensors on L203, but I still have problems. Could you please help me to add 1Wire channel in Mervis for L203 ? I try to use tutorial from YT - create 1W channel, add sensor, set commision mode and than assigne 1W sensor. Till there all is OK. But if i sync this configuration and start debuging mode, there are no values from sensors. Also I can not see 1W sensor as variable in program design.
Any idea, what i did wrong ?
Thank you.